Always Winterize Your Evaporative Cooler

There are a couple of things which you should do to winterize the Evaporative Cooler of yours, or perhaps Swamp Cooler as a few call them. Winterizing the Cooler can not just help you save more maintenance during the next summer, but can truly help to make the device last few years longer. Listed here are the few basic steps that you should do in the fall which will be truly worth your time.
Step one: Always cut off the power cord before working on the Cooler. You do not have to have the strength on to winterize the device and it's usually secure practice to disconnect the power supply before working on any appliance.
Step two: Switch off the valve supplying water for your Swamp Cooler. The water line must also be drained to prevent freezing during the winter. This is usually accomplished by disconnecting the water line in the supply valve and the Cooler. If the water line does not slope all one of the ways the water will not drain by itself. If that's the case, go to the highest end as well as blow through the line to push the water out of the line.
Step three: All Evaporative Coolers are built with a drain at the water pan. The pan should be drained every fall as well as the drain left open to make it possible for any rain water to escape through the winter season. Even after draining you will find dirt as well as mineral sediment in the bottom of the pan. This should generally be washed out. In your Cooler the water is evaporating all summer while the minerals continue building up in the Cooler pan. I love using my shop vacuum to remove all the dirt and minerals. Next with the drain remaining open, I hose out the pan with fresh water to see to it that the minerals are totally out of the pan. This will help to prevent rusting of the metal pan through the winter.
Step 4: I recommend replacing the Cooler pads in the autumn when winterizing the unit. Most folks think of doing this in the spring season when starting the Cooler up. Keep in mind, portable ac reviews canada (click the up coming site) the outdated pads have had minerals starting in all of them through the summer months. The way in which the louver panels are initially made, they cause some rain water to flow into the Cooler and run on the pads. The pads are pressed against the metal louvers and can speed up the rusting all during the entire winter. With fresh brand new pads installed in the fall, you are going to keep the louvers from rusting all all through the winter season.
Step 5: The final step is installing a Cooler cover. If you do this you will prevent the rain water from creating the problems that I mentioned in step four. But more importantly it puts a stop to the outside air from getting into the house or building being supplied by the Evaporative Cooler. Most household Coolers have a damper which could be closed that can prevent the majority of the air from putting in the ducts and getting into the building. A cover is particularly needed if you do not have this particular damper or even if the damper isn't firm enough to stop any air from seeping in.
These are a handful of actions that will help you to prepare the Cooler of yours for the winter months, but in addition can help your Swamp Cooler to last you for years longer and help you save money.