Always Winterize Your Evaporative Cooler

There are a number of items that you must do to winterize your Evaporative Cooler, or perhaps Swamp Cooler as a few call them. Winterizing the Cooler can't only save you more maintenance during the next summer, but can truly help to make the unit last few years longer. Listed below are the few easy steps which you must do in the fall that can be well worth the time of yours.
Step 1: Always cut off of the power cord before concentrating on the Cooler. You don't need the power on to winterize the product and it is always secure practice to disconnect the power source before focusing on any appliance.
Step two: Switch off the valve supplying water for your Swamp Cooler. The water line must also be drained to avoid freezing during the winter. This can be accomplished by disconnecting the water line at the supply valve as well as the Cooler. If the water line doesn't slope all one way the water will not drain by itself. Whenever that is the case, go to the top end and blow with the line to just make the water out of the line.
Step three: All Evaporative Coolers are created with a drain in the water pan. The pan must be drained every fall as well as the drain left accessible to make it possible for some rain water to escape through the winter. Even after draining you are going to find dirt as well as mineral sediment in the bottom level of the pan. This should always be cleaned out. In your Cooler the water is evaporating all the summer when the minerals keep on building up in the Cooler pan. I prefer using my shop vacuum to take out all the dirt and minerals. Next with the drain remaining open, I hose pipe through the pan with water which is fresh to ensure that the minerals are completely out of the pan. This will help to prevent rusting of the metal pan through the winter.
Step four: I suggest replacing the Cooler pads in the autumn when winterizing the device. Most men and women think of doing this in the springtime when launching the Cooler up. Bear in mind, the old pads have had minerals putting up in all of them through the summer months. The way the louver panels are originally made, they cause any rain water to flow into the Cooler and run reviews on arctos portable air conditioner the pads. The pads are pressed against the alloy louvers allowing it to accelerate the rusting all during the entire winter season. With fresh new pads installed in the fall, you will keep the louvers from rusting all during the entire winter.
Step five: The last step is installing a Cooler cover. When you do this you are going to prevent the rain water from creating the problems that I said in step 4. But more importantly it puts a stop to the outside air from entering the house or building being supplied by the Evaporative Cooler. Many residence Coolers have a damper which may be closed that can prevent most of the atmosphere from putting in the ducts and getting into the building. A cover is particularly needed when you do not have this damper or if the damper isn't firm enough to stop any air from seeping in.
These're a few measures that will enable you to to prepare the Cooler of yours for the winter months, but additionally can really help your Swamp Cooler to last you for several years longer and save you money.